The multiplexed network adjustable on demand
For more than 30 years, we have designed and produced reliable and efficient solutions. The Multibloc range is a complete and scalable solution, ideal for managing simple or complex electrical installations in land and sea vehicles.
Our systems meet both the needs of the end customer in terms of ergonomics and ease of use and those of manufacturers in terms of ease of use and simplicity of installation.
The advantages of the solution :
• Reduction of wiring (quantity and installation time)
• CAN or LIN bus communication depending on the equipment
• CI-Bus and NMEA2000 compatible
• Possibility of completing the installation with compatible products
• Backup of the block configuration on the Navicolor or on an SD card









KEEP AN EYE ON THE BATTERY STATUS
Battery Viewer

Precise charge status

Voltage

Remaining
capacity

Consumption
COLLECT AND DISPLAY THE MEASUREMENTS
Bloc 7
Capteur
de courant

Acquisition de mesures analogiques & numériques

Level measurement

Configuration rapide




MANAGE THE EQUIPMENT
Bloc 9
5 ways to manage
the equipment
Protection
6 power outputs
Manual command possible




detoure.jpg)




SWITCH BETWEEN 2 AC SOURCES
Sélecteur de sources
Remote control
Generator start-up
and status
Optimized wiring
Measure AC frequency voltage on 2 inputs

MANAGE ENGINES
Bloc 8
Used to manage motors in both directions of rotation
(examples: blinds, roller shutters, step)

ON-BOARD INTELLIGENCE
Bloc 2
Power bloc for all applications requiring an electrical energy intelligent
on-board management.


MEASURE A SINUSOIDAL SIGNAL
AC1
Allows the measurement of an alternating voltage having
a sinusoidal or pseudo-sinusoidal signal.


ORDERING FROM A DISPLAY
B1
This element is connected to the serial bus through which it sends information and receives commands from the front panel. It cannot operate on its own.
.It contains the protection fuse to the engine battery, the refrigerator protection fuse and it manages the recharging of the batteries.

B2
Used to protect the living area battery with fuse F1 = 50A in the event of a short-circuit or circuit overload. It is also used to isolate it from the rest of the installation so that there is no more consumption when the system is off.

PROTECT THE BATTERY

CONNECT TO OTHER NETWORKS
MULTICOM
Gateway for connecting the Scheiber CAN Bus to specific networks such as
ALDE, Super B or TBB power



COMMUNICATE WITH OTHER PRODUCTS
COMMUNICATION INTERFACES
• CAN/CAN
• CAN/USB
• CAN/NMEA2000
• CAN/RS


CONTROL YOUR INSTALLATION REMOTELY
WIFI SERVER
Access to the local or remote network with 3G-4G key option
Management of audio amplifiers, lighting and roller shutters
Troubleshooting assistance




SEE AND CONTROL YOUR INSTALLATION
DISPLAY
Several displays are compatible with the Multibloc system